Installing a water efficient drip irrigation is very simple. A typical system consists of ½ "plastic tube that tap water from a broken pipe trees, shrubs and flower beds. The plastic tube with nozzles made of plastic, called channels, with permanent establishments. Emitters are essentially mini -sprinklers and are available in different forms, depending on the type of equipment you need water. If you are watering lawns, apply 1 foot of hose with emitters mustfor each square meter of space plant bed.
Their irrigation systems with a few basic components may be, but with parts purchased "a la carte" are added. You also need a punch to pierce the tube and "goof plug" for the repair of defective shock absorbers. Pipes for drip irrigation is thin flexible polyethylene or polyvinyl chloride, typically ¼ "or ½" in diameter. Inner diameter can vary from manufacturer to manufacturer, so it is advisable to purchase pipe and fittingsfrom a single source.
Let's do it themselves,
1 Connect the supply pipe system to a water source, like a faucet pipe or a system of rainwater. If you touch the water in your domestic water supply, with a pressure gauge to check water pressure. If the pressure of more than 50 pounds per square inch, install a pressure reducer fitting before connecting the supply hose. A filter should also be connected to the tap in front of the feeding tube.
2 In the bed position, with the installation of dripEmitters every 18 ". It is also possible to ½" PE pipe preloaded with spotlights. If you use these tubes, cut the tube feeding, once you reach the first bed, and connect the transmitter with a barbed hose fitting. Lay the pipes under the plants so that issuers through the roots.
3 For trees and shrubs, a ring around the branch of a tree. Pierce the filling near the freedom and create a T-piece Cycle of the field around the tree and connect to both outputs on the tee.Use ¼ "pipe for small trees, ½" for larger pieces. Insert lamp in the cycle every 18 ".
4 Use micro-sprays for plants hard to reach. Spray devices can be connected directly to mains power supply or put on short spurs. Sprayers are available in a variety of spray and flow models, choose the best one to be watered the plants.
5 Plants in pots and raised beds can be irrigated with spray applicator. Put the game in pots or takenBeds. Connect a length of ¼ "tube in the head with a clutch and connect the ¼" line on the syringe.
6 Once all branch lines and emitters are installed, delete the system by activating the water and let it flow for a full minute. Then close the ends of the cable and the junction with the figure-8 end beads. Tube can be left exposed or buried under mulch.
0 comments:
Post a Comment